SECURITEX ELSEMA RECEIVER FMR-212 & FMR-224 SERIES RECEIVER

 

 

 

 

 


Securitex Electronic Systems Engineering  (Auto gate Division)
Block 9010 Tampines St 93 #04-145 Tampines Industrial Park A Singapore 528844 Tel: 67852171 Fax: 65850107 sales@securitex.com.sg


Elsema FMR-212 : 12 Volts 27MHz FM Receiver with Relay Output

fmr-212.jpg (57252 bytes)

The FMR-212 is a crystal controlled single channel receiver, comprising of receiving, decoding and relay-output sections. A specially designed LARGE SCALE INTEGRATED CIRCUIT (LSI) is employed in the decoder section, which ensures operation at low supply voltage, highest reliability, associated with very low power drain.

The receiver works on a digitally encoded 27 MHz frequency modulated (FM) signal. It may be used in applications such as the remote control of garage doors, gates, lights, alarms or in any other new or existing installations where the use of conventional wiring is difficult or impossible to accomplish.

If the code of the input signal (from a transmitter) matches the setting of the coding switch on the receiver (up to 4096 combinations), an output is obtained i.e. the relay operates. This relay provides a clean set of contacts for switching DC current up to 5 Amps.

As an antenna, a piece of any type of wire, approximately one meter long, will be sufficient for a reliable control range of up to 400 metres, with our FMT... hand transmitters. A longer wire or a proper 27 MHz CB-Antenna should further improve performance in reception. If a CB-Antenna is used, the shield of the cable must be connected to the "minus terminal".

A push Button (designated as "TEST") is provided for relay output testing.

In the momentary mode (MOM) the relay is only activated while the correct signal is received. When changing the slide switch from "MOM" to "FF" (flip/flop mode) the output relay is toggled with every correct incoming signal. This enables the direct use for switching on/off lights etc. In flip/flop mode, the relay always energizes at the initial "power-up".

If a "latching-on" output is required, for example receiver is used together with a "Panic Button", a wire link is to be fitted as shown below. In such a case the relay can only be reset again by momentarily interrupting the supply.

Care must be taken, not to bring a receiver near strong magnetic fields, such as DC-Motors, speakers, magnets for reed switches, transformers etc. as it would magnetize the coils and may cause severe de-tuning.

To download detail of this equipment please click here (pdf file size 143KB)

To purchase the above receiver card please click here

 


CONTENT ON THIS SITE

  ABOUT US | OUR CLIENTS | OUR SYSTEMS | FREE SECURITY TIPS | CONTACT US |

Securitex Alarm system FAQ   Select right camera system Digital Video Recorder EDR 1600 Everfocus Remote receiver Elsema FMR212
Wireless alarm System LS9001A Monitor Employee Digital Video Recorder Video E-Net Chateau XP Remote receiver Elsema FMR224
Wireless alarm System LS9001A FAQ Monitor vacation home Baby &  Maid CCTV Surveillance System Remote transmitter Elsema FMT101NL
Wireless Intercom system Monitor Children Remote Tele-Surveillance & Global-I system Remote transmitter Elsema FMT301NL
2.4Ghz wireless AV system Monitor Maid Nanny Baby Sitter RIB Automation K5 & K10 Auto Sliding system Remote receiver Elsema FMR201
2.4Ghz wireless AV system FAQ Monitor & Protect Senior Citizen CAME G2500 & G4000 Guad barrier Remote transmitter Elsema 302NL
Servant Access Control system Monitor & Discourage burglary RANGER Auto gate SL1600 sliding Our system Auto gate division
Access control system Application SA 2000 Motion detector security alarm LIBERALI CARDIN Auto barrier system FAAC 750 Auto gate swing
TRIGON Tele-Entry system SA 2000 Motion detector security alarm FAQ O&O K4 & K6 Automatic  barrier FAAC 422 Auto gate swing  
Enterphone Tele-Entry system Motorbike alarm system FAAC 746 Auto gate sliding CAME Swing gate system
Ebelco Electromagnetic Lock Biometric Fingerprint system FAAC 844 Auto gate sliding CAME Sliding gate system
DSC ISO 9001 Certification Aiphone ISO9001 Certification Copyright Notice Privacy Policy

 

 

 

 

 

 

 

 


© 1997 - 2018 Securitex Electronic Systems Engineering. All rights reserved.

SecureCiti International is a subsidiary of Securitex Electronic Systems Engineering
Block 9010 Tampines St 93 #04-145 Tampines Industrial Park A Singapore 528844 Tel: 67852171 Fax: 65850107 Reg. No.: 52838264X