Securitex WDPA-Radiokey was designed for access control into secured facilities where installation of the normal Access Control keypad is not possible. This could be due to the location where the keypad is to be installed is a glass panel or special material which does not allow normal keypad to be installed. Furthermore laying cable from keypad to the access control and locking system is not possible like on marble, granite or even metal clad wall etc.
With the WDPA - Radiokey the keypad can be secured on to this surface using special adhesive and the secured code transmitted to the Wireless receiver (MR1E) integrated to the access control system to release the electromagnetic lock.
Area of used
The WDPA - Radiokey can be use indoor and outdoor area. This keypad is very suitable to be install on Boat, Caravan, Garages Door. Warehouse roller shutter, Automatic Barrier system. Automatic Gate, Office Glass Door and even as a home automation keyboard to activate lights, fan, air-condition etc, as for industries can be use to start stop machine like pumps, compressors etc. The application is limitless.
RADIOKEYB is a numeric battery-powered keyboard for the radio transmission of fixed-length, 5-digit codes (which may be addressed on channels A, B, C and D) to receivers of the Multipass and Roll series.
Can be used to enter and store access codes for any restricted access device such as automatic doors and gates, lights, and so on. The keyboard does not require laying of cables and is also suitable for outdoor installation. The front panel is secured by means of screws and the keyboard itself, with incorporated LED, is protected by a soft-touch semitransparent plastic cover. An appropriate compartment is provided for fitting in the battery.
Note: Features tamper-proof case and electronics. Access to the electronics does not permit to activate the command.
3. TECHNICAL FEATURES
Transmission frequency 433.92 MHz
Duration of transmission about 1 sec
Operating range 40 meters to 70 meters
Battery life 5000 commands, when used with alkaline battery
Type of code Multipass
Signaling devices Rear-illuminated LED and buzzer
No. Of channels 4, can be selected from the keyboard
Dimensions and weight 73 x 80 x 33 mm – 160 grams
Power supply 9V alkaline battery
Insulation Class IP 54
Power consumption Nil when not operating, 5mA for keyboard operations, 30mA for transmission
4. MOUNTING INSTRUCTIONS
Open the case and secure the bottom to the support. Link up the battery and re-close (see fig. 2 and 3). The system is now ready to operate.
Note: In case of outdoor installation, it is recommended that the seals and washers provided be employed in order to prevent water infiltration (see Figure 1).
Once the system has been powered, the codes can be programmed proceeding as follows:
a) Press the programming key on the receiver to access the learning mode.
b) Digit in the code and select one of the four channels (A, B, C or D) by pressing the corresponding key. Exit from the learning mode by pressing the appropriate key on the receiver or wait for 10 seconds for the system to automatically exit from the learning mode.
5.1. ENTERING NEW CODES
The number of codes which may be stored depends on the receiver memory capacity (Multipass RPA function).
a) Digit in a code already stored in the memory of the receiver and press key # (Example: 12345 #).
b) Enter a new code and select one of the four channels by pressing the appropriate key (Example: 67890 A).
c) Repeat step “b” above within 10 seconds to enter other new codes
d) After 10 seconds of a code not being entered, the system automatically exists from the programming mode and becomes operative again.
Pressing of any key set off the buzzer and light up the LEDs. After transmission has been made or upon the * key being pressed, the system returns to stand-by. Pressing of the # key permits to program and enter new codes via radio commands (Multipass RPA function). The keyboard is provided with a battery charge indicator which sets off both an intermittent warning light and the buzzer when the battery is flat.
MORE DETAIL ON THIS SYSTEM CLICK THE LINK